One UNO board is configured as I2C Bus Master and the other UNO is configured as a Slave device. The potentiometers are connected to respective Analog Input pins (A0) and the LEDs are connected to a Digital IO Pin with PWM (Pin 9). To make things interesting and actually see the communication, I added a couple of LEDs and Potentiometers (one set for each UNO Board). In this demo, I connected two Arduino UNO boards to communicate over I2C Bus. To demonstrate the working of I2C in Arduino, let us build a small circuit. If you are using any other board then the following table will be useful to you as it describes the I2C pins on all the popular Arduino boards.ĪTmega328P Microcontroller used in Arduino UNO and Nano supports I2C Data Transfer speeds up to 400 kHz. In R3 of original Arduino UNO, there are two more pins near Digital IO Pin 13 (near the USB socket), dedicated to SDA and SCL. The A4 pin acts as SDA while the A5 pin acts as SCL. If you take a look at the pinout of Arduino UNO from the tutorial “ ARDUINO UNO PINOUT”, Analog Input pins A4 and A5 have an alternative function of I2C. I2C in ArduinoĪrduino supports I2C Communication. For more information on that, visit “ Basics of I2C Communication”. I made an extensive tutorial on basics of I 2C Communication. Using this address, master selects a particular slave for data transmission (send or receive) and the selected slave responds according to request. Each slave device connected to the I2C bus has a unique 7-bit address. I2C network supports multiple masters and multiple slaves (but we usually see single master and multiple slaves). The clock signal is also supplied by the master. Bus Masters are responsible for sending and receiving data to and from the slave devices. There are two types of devices that connect to the I2C Bus: Master and Slave. Data is transmitted through the SDA line while the SCL line is used to synchronize the devices with the clock signal.īoth these bus lines are open-drain drivers and hence you have to use pull-up resistors to keep them HIGH. The I2C Bus consists of two wires called the Serial Data (SDA) and the Serial Clock (SCL). This may not seem much but it is sufficient for interfacing sensors, memories and displays at small distances. Using I2C, you can transmit data at rates 100 kbit/s (clock 100 kHz – Standard Mode), 400 kbit/s (clock 400 kHz – Fast Mode), 1 Mbit/s (clock 1 MHz – Fast Mode Plus) and 3.4 Mbit/s (clock 3.4 MHz – High Speed Mode). Hence, it is sometimes also known as TWI (Two Wire Interface). Make your own library, from Wire.h, by duplicating all functions(but will not solve the DUE as I2C slave), or Program directly the TWI registers.I2C or I 2C is short for Inter-Integrated Circuit, a synchronous serial communication protocol developed by Phillips for communication between a fast Microcontroller and relatively slow peripherals (like Memory or Sensors) using just two wires. To make the 2 I2C buses work at the same time, I see two possibilities: And if your DUE board has to be an I2C master for a bunch of I2C slaves, and at the same time an I2C slave for an I2C master device, you will meet the same issue. The 2 I2C buses can work together, but the Wire.h library is not intended for that purpose. I guess you know you can connect several I2C slaves on the same bus (select TWI0 (SDA1/SCL1) or TWI1 (SDA/SCL) and use the library).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |